Page 1 of 1

Flap Actuator

PostPosted: Wed Dec 04, 2013 1:31 am
by Hank Sproull
I am on my second flap actuator this one was an exchange from Cessna
Lasted 770 hrs and is making a terrible noise.
The standby motor drive roll pin is also sheared.
Can any one advise if they have similar service difficulties?
I have checked the rigging to see if flaps are not not bottoming in the full down and up positions?All looks ok?

Any help would be appreciated
Thanks

Re: Flap Actuator

PostPosted: Wed Dec 04, 2013 12:50 pm
by candyman
There is an amended rigging procedure for the flaps. Using the newest procedure may solve your problem. Let me know if i can be of any further help.

Re: Flap Actuator

PostPosted: Thu Dec 12, 2013 1:25 am
by Hank Sproull
Thanks Candyman
I have since found the stby motor drive had shared off in the rubber drive coupling.
Since removing the stby motor and drive assy all works and sound just fine.
Hank